SEASAFE MODEL SSRX/01 ALARM & TRACKING RECEIVER
10 SeaSafe Equipment Introduction: Congratulations on your purchase of the Seasafe SSRX/01 Alarm and Tracking Receiver. Used in conjunction with t
11 SeaSafe Equipment Specification: Frequency…………………………………………………………………173.4875 MHz Frequency Stability………………………………………………………………15 PPM Dimensions…
12 SeaSafe Installation (To be carried out by a qualified Marine or Automotive Electrician only) a. Receiver The Seasafe Receiver may be operate
13 SeaSafe automatically charged when the receiver is connected to the vessel 12 VDC power supply. Batteries are installed by the Seasafe dealer upon
14 SeaSafe Receiver Mounting Cradle Assembled Receiver mounted in cradle Receiver Cradle mounting holes (use appropriate hardware for mounting s
15 SeaSafe b. Power / Auxiliary Output Cable The receiver is supplied with a connection cable and plug. The cable consists of three wires. A red „pos
16 SeaSafe Typical „Alarm Output‟ connection to peripheral device via external relay Appropriate external relay. Minimum coil resistance of 1
17 SeaSafe d. Collapsible Directional-Antenna The directional or Yagi antenna is a portable hand-held marine grade aluminium antenna. It should be sa
18 SeaSafe System Operation: Once the receiver and omni-directional antenna have been correctly installed, the Seasafe Receiver is ready for opera
19 SeaSafe receiver‟s in-built alarm siren will emit a high pitched audible alarm tone. The volume level of this alarm is factory set and cannot be a
2 SeaSafe CONTENTS 1. Technical support 2. Warranty 3. Regulatory compliance 4. Box contents 5. Receiver Layout and Controls 6. Equipment intr
20 SeaSafe to systematically depress the “SIGNAL GAIN” switches down from number “6”. The signal strength indications will reduce in intensity. The
21 SeaSafe Tracking a Seasafe Personal Transmitter signal using Seasafe Receiver and Directional Antenna (note: the antenna is held in the vertical
22 SeaSafe Accessories: a. Directional Antenna Mast-Mount Adapter (Optional) The directional mast-mount adapter is a marine grade aluminium bracke
23 SeaSafe Aluminium Directional-Antenna Mast-Mount Adapter Directional-Antenna Clipped into Mast-Mount Adapter
24 SeaSafe b. Rubber Protection-Holster & Neck Strap (Optional) The protection holster and neck strap allow the receiver to be comfortably used
25 SeaSafe c. Audio Headset (Standard) The Seasafe receiver is supplied complete with a lightweight audio headset. Under conditions of extreme ambien
26 SeaSafe Copyright: Copyright Seasafe Pty Ltd 2007 International Patent Pending Specification subject to change without notice
27 SeaSafe SEASAFE MODEL SSTX/01 PERSONAL ALARM & TRACKING TRANSMITTER
28 SeaSafe CONTENTS 1. Technical support 2. Warranty 3. Regulatory compliance 4. Box contents 5. Layout 6. Equipment introduction 7. Equipmen
29 SeaSafe Technical Support: For any technical questions or for support, please contact your local Seasafe distributor or visit: Internet: http://
3 SeaSafe Technical Support: For any technical questions or for support, please contact your local Seasafe distributor or visit: Internet: http://w
30 SeaSafe Warranty: Seasafe warrants this product to be free from defects in materials and workmanship for 12 months after the date of purchase.
31 SeaSafe Regulatory Compliance: This device complies with AS 42868.2 as amended by LIPD (Low Interference Potential Device) 24 August 2005. In pa
32 SeaSafe Box Contents: Included in the purchase of the Seasafe SSTX/01 Personal Alarm & Tracking Transmitter are the following components:
33 SeaSafe Seasafe SSTX/01 Transmitter Box Contents 1. Arm-Band mounting adapter 2. Personal Transmitter 3. Antenna 4. Battery 5. Belt-Clip 1
34 SeaSafe Ergonomic Neoprene Arm-Band is not supplied in the box but is supplied as part of the kit 1. Large Arm-Band 2. Small Arm-Band 3. Med
35 SeaSafe Seasafe Model: SSTX/01 Personal Transmitter Lay-out & Controls 1. Neoprene Arm-Band 2. Arm-Band mounting adapter 3. Man
36 SeaSafe 1. Automatic Water-Activation Sensors Personal Transmitter Back 1. Flexible Antenna 2. Arm-Band Mounting Adapter / Belt-Clip mountin
37 SeaSafe Equipment Introduction: Congratulations on your purchase of the Seasafe SSTX/01 Personal Alarm and Tracking Transmitter. Used in conjunc
38 SeaSafe Equipment Specification: Frequency…………………………………………………………………173.4875 MHz Dimensions………………………………………………80mm H x 78mm W x 32mm D Weight (w
39 SeaSafe System Operation: (To be carried out by a qualified Marine or Automotive Electrician only) a. Battery The Seasafe SSTX/01 is a personal
4 SeaSafe Warranty: Seasafe warrants this product to be free from defects in materials and workmanship for 12 months after the date of purchase. I
40 SeaSafe time the „O‟ ring appears brittle, cracked or not in perfect condition, a replacement should be obtained from your nearest Seasafe dealer
41 SeaSafe b. Flexible Antenna The Seasafe SSTX/01 transmitter is supplied with a „screw-on‟ flexible antenna. Prior to use, the antenna should be se
42 SeaSafe transmitter and then attach the transmitter to the neoprene arm-band. The arm-band may be loosened or tightened by adjusting the Velcro s
43 SeaSafe Rear view of transmitter showing Arm-Band mounting adapter Side view of transmitter showing belt-clip
44 SeaSafe d. Optional Dive-Cap The Seasafe transmitter may be automatically activated upon submersion in water or manually activated by depressing
45 SeaSafe e. Man-Overboard Operation If you intend to use the device as a „Man-Overboard‟ alarm, once on board the vessel, the transmitter should be
46 SeaSafe f. Lost-Diver Operation In order to use the Seasafe transmitter for underwater of diving applications, you need to purchase an optional r
47 SeaSafe earliest opportunity. The dive-cap may be attached to the transmitter by means of a lanyard connected to the eye on the divecap and one of
48 SeaSafe Accessories: a. Dive-Cap The optional rubber Dive-Cap is for use is underwater applications or in marine activities where it is expecte
49 SeaSafe Copyright: Copyright Seasafe Pty Ltd 2007 International Patent Pending Specification subject to change without notice
5 SeaSafe Regulatory Compliance: This device complies with AS 42868.2 as amended by LIPD (Low Interference Potential Device) 24 August 2005. In par
50 SeaSafe DAFAR INTERNATIONAL INC. TEL:+886-2-2345-5738 FAX:+886-2-2345-5743 http://www.dafar.com.tw
6 SeaSafe Box Contents: Included in the purchase of the Seasafe SSRX/01 Alarm & Tracking Receiver are the following components: Seasafe Mod
7 SeaSafe 1. Audio Headset 2. Mounting Cradle 3. Power Cable / Plug 4. Receiver 5. Batteries(Installed by agent) 1 2 3 4 5
8 SeaSafe 1. Omni-Directional Antenna 2. Directional Antenna Omni- Directional and Directional Antennae are not supplied in the box but are suppl
9 SeaSafe Seasafe Model: SSRX/01 Receiver Lay-out & Controls 1 8. “Volume Up” Switch 9. “Volume Down” Switch 10. “Power On” Swit
Comments to this Manuals